User Tools

Site Tools


puppack_troubleshoot

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
puppack_troubleshoot [2019/05/21 12:55]
pinupadmin
puppack_troubleshoot [2019/05/21 12:57] (current)
pinupadmin
Line 79: Line 79:
 </​file>​ </​file>​
  
-if you don't have a puplog.txt file then you are not configured correctly.+if you don't have a puplog.txt file then you are not configured correctly.  Most common is forgetting to press f1 and make sure 'use external'​ is checked, or using the wrong rom/table version.
  
 Make sure there are no blocked dlls in your vpinmame folder like the '​dmddevicepup.dll'​. Make sure there are no blocked dlls in your vpinmame folder like the '​dmddevicepup.dll'​.
Line 87: Line 87:
 also, if you are NOT using freezy dmddevice.dll,​ like perhaps you are using luckys'​ pin2dmd dmddevice.dll then you will not be able to use any puppacks that use PuPCapture (most will in the future). also, if you are NOT using freezy dmddevice.dll,​ like perhaps you are using luckys'​ pin2dmd dmddevice.dll then you will not be able to use any puppacks that use PuPCapture (most will in the future).
  
-=====   ​Performance: ​  ​=====+===== Performance:​ =====
  
 If you have video stuttering or artifacts with PuP-Packs with VPX… you most likely don't have VSYNC properly setup in VPX. Set "FPS Limiter/​VSYNC"​ to 1, and "​Maximum Pre-Rendered Frames"​ to 1 in VPX Video Options. This can also be set per-table in the Table'​s "User Customization"​ options, so check that as well. If you have video stuttering or artifacts with PuP-Packs with VPX… you most likely don't have VSYNC properly setup in VPX. Set "FPS Limiter/​VSYNC"​ to 1, and "​Maximum Pre-Rendered Frames"​ to 1 in VPX Video Options. This can also be set per-table in the Table'​s "User Customization"​ options, so check that as well.
puppack_troubleshoot.txt · Last modified: 2019/05/21 12:57 by pinupadmin