User Tools

Site Tools


puppack_troubleshoot

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
puppack_troubleshoot [2019/05/21 12:55]
pinupadmin
puppack_troubleshoot [2019/05/21 12:57]
pinupadmin
Line 79: Line 79:
 </​file>​ </​file>​
  
-if you don't have a puplog.txt file then you are not configured correctly.+if you don't have a puplog.txt file then you are not configured correctly.  Most common is forgetting to press f1 and make sure 'use external'​ is checked, or using the wrong rom/table version.
  
 Make sure there are no blocked dlls in your vpinmame folder like the '​dmddevicepup.dll'​. Make sure there are no blocked dlls in your vpinmame folder like the '​dmddevicepup.dll'​.
Line 87: Line 87:
 also, if you are NOT using freezy dmddevice.dll,​ like perhaps you are using luckys'​ pin2dmd dmddevice.dll then you will not be able to use any puppacks that use PuPCapture (most will in the future). also, if you are NOT using freezy dmddevice.dll,​ like perhaps you are using luckys'​ pin2dmd dmddevice.dll then you will not be able to use any puppacks that use PuPCapture (most will in the future).
  
-=====   ​Performance: ​  ​=====+===== Performance:​ =====
  
 If you have video stuttering or artifacts with PuP-Packs with VPX… you most likely don't have VSYNC properly setup in VPX. Set "FPS Limiter/​VSYNC"​ to 1, and "​Maximum Pre-Rendered Frames"​ to 1 in VPX Video Options. This can also be set per-table in the Table'​s "User Customization"​ options, so check that as well. If you have video stuttering or artifacts with PuP-Packs with VPX… you most likely don't have VSYNC properly setup in VPX. Set "FPS Limiter/​VSYNC"​ to 1, and "​Maximum Pre-Rendered Frames"​ to 1 in VPX Video Options. This can also be set per-table in the Table'​s "User Customization"​ options, so check that as well.
puppack_troubleshoot.txt · Last modified: 2019/07/23 14:44 by pinupadmin